AL12+ Series Offgrid Solar Cabinet (10kVa / 200A)

Our prewired cabinets are designed to be reliable, affordable and to make onsite installation much quicker and easier. Hand built in our Toowoomba workshop, we take pride in the quality of our products and the attention to detail in the design and build process. We only use quality equipment, so you get a system that is reliable.

InformationSpecsDownloads

Victron MultiPlus II inverter

At the heart of the cabinet are Victron MultiPlus-II inverter/chargers, configured together to deliver a full 10kVa of clean 230V power. They run silently, carry the big start-up loads from bore pumps, welders and workshop machinery, and take over automatically the moment the grid drops out. PowerAssist can also top up a smaller generator so you are never left short.

Victron RS MPPT solar controller

A Victron SmartSolar MPPT RS charge controller tracks the maximum power point of your solar array all day, turning high voltage panel input into efficient battery charging. Twin trackers let you run panels in different directions or strings, and the high input voltage keeps cable sizes and voltage drop down on long roof runs.

Victron Cerbo & Touch monitoring

A Victron Cerbo GX ties the whole system together and puts it on your phone, tablet or computer. The colour touch screen shows solar yield, battery state of charge, load and generator input at a glance, and Victron Remote Management lets us look in and adjust settings remotely when you need a hand.

Pylontech US5000 batteries

The cabinet is built to house Pylontech US5000 lithium modules - 48V, 4.8kWh each - with the battery management system talking directly to the Victron gear over CAN bus. Add modules as your demand grows, and the batteries stay protected, balanced and correctly charged without you having to think about them.

Premium lockable cabinet

Everything is built into a premium lockable cabinet with removable panels for service access and plenty of airflow around the equipment. It is built to live in a shed, a garage or a machinery room and still look sharp after years of Australian conditions.

Pre-wired, fused and configured

Each cabinet is assembled and wired by our technicians with the correct cable sizes and lugs, DC fusing and isolation on every circuit, earth bars, labelled breakers and tidy cable management throughout. Inverters, chargers and batteries are programmed and tested together before the cabinet leaves the workshop, so it arrives as a finished system rather than a box of parts.

Easy onsite installation

Installation is a simple three step job: connect your solar panels, wire the power from the cabinet to feed your switchboard, and wire in your generator. Everything else is already done, so most systems are up and running in a day.